The best flat roof roofing material is without a doubt a single sheet of rubber custom made for weather-proofing flat roofs, such as for example Firestone’s EPDM product.
This is laid directly onto roof boarding, itself commercial roofing contractors orange county supported by the roof rafters and nagging. Insulating material is normally laid in the space between your two, and if you’re renewing your flat roof anyway you might as well take the opportunity of renewing that simultaneously.
This will almost certainly function as recommendation you receive from any reputable builder or roofer advising you on replacing your existing flat roof.
Until recently the most used material for a fresh flat roof was bituminous felt laid in three layers, the initial layer nailed down and top of the two bonded to the one beneath with mastic bitumen. Based on the material used, this could mean heating a solid bitumen-based compound to make it liquid, and then pouring it onto the underlying felt and spreading it evenly over the whole area of the roof.
Then you had to wait for the compound to cool before applying the next layer, and at the end spreading a layer of stone chippings over the roof and bonding it with a chipping compound, this being to reflect the sun’s rays preventing the felt and bitumen degrading quickly.
This was altogether a fairly messy, complicated and time-consuming job best left to the professionals. In addition, there were several stages where it was very easy to neglect to make the roof weather-proof, e.g. where in fact the edge of the felt met the existing tile or slate roofing of the pitch roof.
In addition, if, or rather when, there developed a leak in the flat roof, it will be very difficult and messy to discover wherever the rain was getting back in. Seldom would the manifestation of the leak on the ceiling of the room below be directly below the source of it. Water could get through a weakness in the bitumen felt and travel along a rafter before descending to the ceiling board below.
The new generation of rubber-based flat roofing systems are far superior. Assuming you have reasonable DIY abilities then you can certainly probably do-it-yourself, with one other person to assist. You can easily find a local supplier of rubber flat roof roofing material online, and the current price is only around �6.65 per square metre.
Most suppliers slice the material to the exact shape and size that you require so are there no unnecessary joins, meaning no weaknesses and an extremely long-lasting, leak-proof roof.
The vital area of the whole process is to make sure that there are no gaps between your rubber roof and any existing pitch roof where rain may penetrate. To ensure there are no problems it’s important to run the rubber material up and under the tiles or slates of the adjoining pitch roof so that any rain dripping from the lower-most row falls onto the rubber, without possibility of it over-lapping the edge and getting within the pitch roof.
Also, make sure that the prevailing slope of the flat roof towards the guttering or other method of water escape is maintained. The rubber is simply glued onto the roof boards and sealed where appropriate with metal brackets or bitumen in such a way that rain penetration is impossible. Mind that the glue covers the entire underneath of the rubber so as to avoid bumps in the top which could obstruct the drainage of the water away.
Rubber roofs have been shown to last for well over 50 years under all weathers, so that it really is the only real flat roof roofing material that you need to consider when deciding on a new flat roof.